RC-Factory Yak 54 3D Aerobat EPP (1020mm)

An amazing machine with a striking colour scheme! Handles windy conditions well and with a Hyperion Zs2213-18 swinging an APC-E 10 x 4.7SF prop on a 1300mAh 3S (11.1V) LiPo battery, long 3D unlimited flights are easily achieved. The huge control surfaces on this model enable  extreme performance and and provide exceptional authority.

Features:
* Full EPP construction
* Extra large control surfaces
* Incredible control authority
* Smooth pattern performance
* Ideal 3D trainer
* Almost indestructible
* Builds in 1 to 2 evenings
* Composite landing gear
* Repairs easily with standard CA

Specification:
* Wingspan: 1020mm/40.2in
* Length : 980mm/38.6in
* Flying weight: 380-460g/13.4-16.2oz
* Motor Size: 120~150W brushless
* Recommended prop: APC 10 x 4.7SF/APC-E 11 x 4.7SF
* RC functions: ailerons, elevator, throttle, rudder

Kit contents:
* Pre-printed EPP airframe parts
* Hardware accessory pack
* Carbon fibre rod
* Light weight foam tyred wheels
* Carbon undercarriage
* Motor mount
Note: Illustrated assembly instructions available on line

Required:
* Power set
* Servos: 4 x 9~12g. Our recommendation: EMax ES08MA (stock no.406128)
* Y-lead (optional for ail servos)
* Battery:  650~1200mAh 3S (11.1V) LiPo
* Radio System: TX/RX min 4-channel
* Prop APC-E 10 x 4.7SF (dependent on motor choice)
* Standard CA glue

Our recommended power sets:

Standard (225W): A2217-9 brushless outrunner motor (stock no. 409693), 30A Pro ESC (stock no. 400214), APC-E 10 x 4.7SF (stock no. 411385)

Light (175W): Hyperion zs2209-24, 20A ESC, APC-E 9 x 4.7SF prop, 600mAh 3S (11.1V) LiPo. Good quality 9g-12 servos are recommended for 3D but if a docile setup is required, cheaper 9g servos will do the job. With this light configuration you need to pay close attention to saving every gram posible. If you are not experienced in building foam type models such as this then please choose our performance power setup. If kept light this setup can prove very rewarding.

Performance (280W): Hyperion zs2213-18 (stock no. 409747), 25~30A ESC, APC-E 10 x 4.7SF prop, 1000~1200mAh 3S (11.1V) LiPo. Good quality high power metal gear servos are a must with this setup. Ideal for most modellers. The weight is less critical; this power set will get you out of trouble. This is a good good choice if learning to prop hang.