RC Factory Revolto 3D Aerobat EPP Green (1000mm)

The Revolto is Rc Factory’s newest 1m model V3 series with increased stiffness and torsion rigidity. We have beefed up everything, but especially the torsion rigidity of the fuselage – so that fuselage twist in fast rolling maneuvers is now totally a thing of the past. The wing is thicker too, for better tolerance of the most insane, high-G stunts. Now with full rotational elevator for massive control!
Those that are familiar with the previous 39” models will appreciate the new hardware and construction including rear tail control push rod assemblies with adjustable end links and new epp bracing for easy assembly. While creating a new ground up air-frame the duel aileron servos have now been re-located which creates a plush/clean look. The over all flight envelope has increased greatly giving a sense of unreal control authority and increased roll rate was also achieved with the addition of outer counter balance tabs. This model was designed for the pilot wanting to learn the “next step” and also those who choose a balsa 3d model alternative. * Spinner not included *

Two different power systems are now available for the V3 models. The 58g motor/20A ESC setup is ideal for light weight and slower flying acrobatics, while the 72g motor/30A ESC setup is the heavier setup with more thrust.

Specification
* Wing Span = 39″ 1000mm
* AUW: 400-500g (depending on components used)
* All New V3 construction.

Recommended Required Components:
* 50-72g 900-1200kv brush-less motor
* 20A ESC w/ 58g motor or 30A Esc w/ 72g motor
* 4-6ch Micro Receiver
* (4) 10-16g MG Servo’s
* (1) 6-8″ servo extension)
* 10×3.8/10×4.7 Prop w/ 58g motor setup
* 11×5.5 Prop w/ 72g motor setup
* 3s 800-1500mah Lipo