Multiplex FunJet Ultra Sports Jet ARTF Kit (RB403715)

Just when you thought your Multiplex FunJet was one of the fastest planes in its class, the Multiplex design team went ahead and upped the ante with the ultra-fast, ultra-durable FunJet Ultra. With the right motor/ESC/LiPo, this hotter-than-hot jet will accelerate up to 125 miles per hour while maintaining impeccable flying precision. The FunJet Ultra is constructed with high density Elapor foam, providing considerable structural strength for high stress aerobatics and rough landings.

Designed for intermediate and advanced pilots, the FunJet Ultra brings lightning speed and uncompromising accuracy to your next flying adventure.

Features:
*Very robust ELAPOR construction
* Removable canopy for easy battery swap
* Down thrust can be accurately fine-tuned
* Designed for 3200mAh 3S (11.1V) LiPo packs
* Easy to hand launch, easy to land
* Smooth handling at low and high speeds
* Direct precise control response
* Capable of speeds in excess of 125 MPH
* Requires assembly

Specification:
* Wingspan: 785mm/31in
* Length: 750g/29.5in
* Weight: approx. 879g/31 oz.
* RC Functions: Elevons (Delta mix), Throttle
* Colour: Unpainted WHITE with decal sheet (included)
* Recommended battery: 3200mAh 3S (11.1V) or 4S (14.8V) LiPo (depending on power setup)
* Flight Characteristics: Ultra Fast
* Target User: Intermediate to Advanced

Kit Contents:
* Moulded WHITE ELAPOR (particle foam) parts
* Moulded Motor Mount & Bulkhead
* Carbon Fibre Spars
* Small Parts Set – canopy locks, servo fairings, control rods, servo linkages
* Decal sheet
* Easy to follow illustrated instructions

Required:
* Motor: 350-800W brushless
* ESC: 50A – 80A
* Propeller: 6 x 5.5 electric (depending on motor choice)
* Servos: MPX Nano Pro Karbonite (2 required) or alternatively our TowerPro MG16R 18.8g digital servos
* Servo extension leads: 300mm/12in (2 required)
* Radio system: min 4Ch TX and RX
* Battery: 3200mAh 3S (11.1V) or 4S (14.8V) LiPo depending on power setup
* Glue: We recommend Multiplex Zacki – developed specifically for Elapor – or cyano & cyano activator (kicker) or alternatively UHU-por. If you use Zacki, you will not need kicker or activator. It is not possible to use white glue or epoxy.

{MULTIPLEX-FUNJET}