Ele RC Mini Stick ARF Inc Brushless Motor

Phil Kraft’s original Ugly Stik was released to the public in the May-June issue of Radio Control and Model Aircraft World in 1966. There have been several variations of this classic design in various sizes.

For those of you who continue to be stik fans we are now offering this cute little (580mm/ 22.8in wingspan) version – ideal for carrying fully assembled in the boot of the car for those calm evening, flying opportunities

Our Mini Stick has a flying weight of only 110g making it ideal for either indoors or out – on calm days.

Designed for 2S (7.4V) LiPo operation, it is supplied with a pre-installed brushless motor. The precise, laser-cut balsa and light ply parts have been accurately assembled and pre-covered in red transparent film to an exceptionally high standard.

With aileron, elevator, rudder control, this cute little plane can be flown either very slowly, or reasonably fast. With your hand on the throttle stick; the choice is yours.

Features:
* Traditional balsa and ply construction factory-assembled airframe
* Beautifully finished in transparent red film
* Factory fitted brushless outrunner motor
* Minimal assembly required approx. 1-2 evenings
 
Specification:
* Wingspan: 580mm / 22.8in
* Length: 440mm / 17.3in
* Flying weight: 110g / 3.9oz
* Motor: AEO C10 2900KV, 18W, thrust 97g / 3.42oz (installed)
* Prop: GWS 4 x 2.5 (included)
* RC functions: elevator, rudder, throttle, optional ailerons

Contents:
* Fully built-up and covered airframe (fuselage, one-piece wing, tailplane/elevator, ailerons, fin/rudder
* Accessory pack (inc. CA hinges, control horns, carbon pushrods, Z-bend connectors, heatshrink and wing bands)
* Factory fitted AEO C10 2900KV brushless outrunner motor
* Propellor: GWS 4 x 2.5 (prop saver included)
* Prebent wire landing gear and light weight wheels
* Full colour decals
* Full colour assembly instructions (please note the recommended balance point should be around 30-45mm from the leading edge of the wing and not 100mm as printed)

Required:
* ESC: 6A
* Servos: 3 x 3.7g GoTeck GS-3707
* Battery: 200~ 450mAh 2S (7.4V) LiPo
* LiPo Balance Charger
* Radio system: TX/RX min 4-channel
* CA glue