Donuts Models Gee Bee R3 Indoor Pylon Racer (700mm)

Donuts Models Gee Bee R3 Indoor Pylon Racer
Best described as ‘cartoon scale’, this model – inspired by the famous Gee Bee R3 – is designed primarily for indoor flight and is ideal for relaxed flying or pylon races. Its reduced mass makes the R3 capable of ultra-slow flight but also rapid acceleration.

Although this model has been designed specifically for indoor flying, it may be flown outdoors in very calm conditions. It can be flown quite quickly and is especially suited to indoor pylon racing.

Features:
* Innovative Donatas, flat-section design
* Water-jet cut and screen printed 3mm Extrupor airframe parts
* Simple assembly

Specification:
* Wingspan: 700mm/27.5in
* Length: 580mm/22.8
* Flying weight: 80-100g

Kit contents:
* EXTRUPOR water jet cut and screen printed airframe parts.
* Carbon rod (undercarriage, fus/wing struts/reinforcement, control rods).
* Nylon thread (bracing, elevator and rudder pull-pull closed loop).
* Accessory set (wheels and mounts, horns)
* Full colour illustrated instructions

Required:
* Motor: AP19B 
* ESC: 10A 
* Battery: 150~300mAh 2S (7.4V) LiPo
* Servos: 3 x EP 6.0 or JR DS 318 / ES 316 or similar – TowerPro SG51R 
* Hinge tape 25mm Blenderm
* Recommended prop: GWS 7 x 3.5 or 8 x 4.3SF (dependent on motor choice)
* Radio system: min. 4-channel TX with light weight RX
* UHU por or foam safe CA